EPRO PR6423-003-030+CON021 Axial vibration sensor

Information about the EPRO PR6423-003-030+CON021 Axial Vibration Sensor is as follows:

Basic information
Brand: EPRO
Model: PR6423-003-030 + CON021
Type: Axial vibration sensor
Main features and functions
Real-time monitoring: It can monitor the vibration of equipment or structures in real time, and capture small vibration changes through sensors.
Fault warning: When abnormal vibration is detected, an early warning signal can be sent to notify relevant personnel for inspection and maintenance in time to prevent equipment damage or accidents.
Data acquisition and analysis: May have data acquisition and analysis capabilities to record and analyze vibration data of equipment or structures to help users identify potential problems or trends.
Flexible configuration: Allows users to set parameters and adjust thresholds based on actual requirements.
Easy to use and maintain: May provide a friendly user interface and programming software, so that users can be more convenient in the use and maintenance process.
Technical parameter
Measuring range: 0 ~ 50mm (measuring range is customized by the user)
Accuracy: ±1% (full scale)
Ambient temperature: -20 ℃ ~ +100 ℃
Relative humidity: ≤80%
Power supply: External power supply may be required. Specific parameters are not mentioned.
Output signal: The AC voltage signal superimposed on the DC voltage is proportional to the shaft vibration.
Internal resistance: 100k
Response time: 15 (may refer to response time of 15 ms or other units, need further confirmation)
Connection and installation
Connection of the sensor to the preprocessor: there are two options: by LEMO plug connection or by screw terminal connection.
Protection level: CON021 series protection level is IP20.
Installation environment: Sensors and precursors can be installed in hazardous environments after installing the grid (but CON… / 91… Series preprocessor can not be used in explosion-proof situations).
Fittings and calibration
Standard calibration material: 42CrMo4, according to SAE4140 standard. Calibration can also be made with other materials if requested by the user.
Standard accessories: May include sensors, fastening nuts, connection cables, etc.